Snailfly Crossbars Customized For ******* Ford Explorer Blac

Descripción

******
****** Intermediario comercial: MIBICY
****** Powered by. MAUJA GROUP.
******
****** ¿Si tienes dudas?: No dudes en preguntar, antes de ofertar.
****** No dudes en preguntar, antes de ofertar.
******


NOMBRE EN INGLES: Snailfly Crossbars Customized for ******* Ford Explorer Black Adjustable Roof Racks Cross Bars with Lock


This fits your.


* Make sure this fitsby entering your model number.

* COMPATIBILITY - These crossbars are compatible with ******* Ford Explorer XLT, Limited, Hybrid, ST, and Platinum.

* AERODYNAMICS - with wind tunnel tested teardrop shape design, the roof rails are quiet and exceptionally aerodynamic.

* MATERIAL - High qulity aluminum alloy construction and black powder-coated finish resists corrosion and rusting.

* EASY INSTALLATION - Directly attach to the car original side rails, easy to assemble and remove without modification. Package comes with a complete set.

* CAPACITY - Maximum 165lbs loading capacity when distribute the weight of the cargo evenly. Strength and compatible with a wide range of accessories like cargo carrier, bikes or kayaks rack, roof box, snowboards, and etc.

* NOTE - Please check the INSTALLATION VIDEO on the page.

Product Description

INSTALLATION INSTRUCTIONS
1. Use the key to take the covers of the end caps.
2. Use the large allen key to loosen the brackets so that you can clamp it where you would like on your roof. Pay attention to orientation. There is an arrow pointing to front of car.
3. Next step is to get the cross bars adjusted to the width. There are screw holes on the bar and end caps that will need lined up.
4. Loosen the small allen head screw, that is in the end of the black portion of the crossbar, until there is a half inch of screw pulled out. It is now a spring button to adjust the width.
5. Slide the bars into the end caps. Set one side with a screw. Push the allen head screw tab and wiggle each side to pull the black portions out equally on each side.
6. Once you can secure the screw on the opposite side, tighten all allen heads to a good hand tightness. Don t over do this part. Tight enough to not be able to move any of when pushed and pulled.
7. Reinstall the end cap covers.


------------------------------------------------------------------------------
------ POLITICAS
------------------------------------------------------------------------------

Nuestros proveedores se encuentran ubicados en el exterior, por lo que los tiempos de entrega pueden variar dependiendo de la ubicación del mismo; por favor, validar disponibilidad de tiempos en la parte superior de la publicación junto al precio.

CONDICIONES DE LA VENTA:

* Somos Intermediarios Comerciales y Tienda Virtual, actuamos a través del modelo de contrato de mandato con representación el cual se ejecuta y se toma como aceptado al momento de realizar el pago de su producto en esta plataforma.

Garantía del vendedor: 30 días